Connecting youBot to external computer

You can control youBot with an external PC after you connect the hardware with your PC via Ethernet.

Please note that to work with external PC the internal PC must be shut down.

Using KUKA youBot arm and base

If you are using both the KUKA youBot base and arm you should connect the Ethernet cable to the remaining port on the arm, as shown below:

Correct Ethernet Cabling

Using only KUKA youBot arm

If you are using only the KUKA youBot arm you should connect the ethernet cable to the port on the right (close to the on/off button), as shown below:

Correct Ethernet Cabling

Please remember that when you are connecting only the arm you have to change the Joint topology in youbot-manipulator.cfg file accordingly.

Using only KUKA youBot base

If you are using only the KUKA youBot base you should connect the ethernet cable to port ehtherCAT1, as shown below:

Correct Ethernet Cabling

Using KUKA youBot base with two arms

If you are using KUKA youBot base with two arms you should connect the Ethernet cable to the remaining port on the second arm.