Microsoft LifeCam
From youBot wiki
Contents
Microsoft LifeCam
- Interface: USB2.0
- Power supply: Through USB
For more information, visit the official website.
Mounting the camera on the youBot arm
To mount the camera on the youBot arm, you will need the following pieces
- 1 x Universal sensor carrier
- 1 x pair of brackets (left and right)
- 1 x M3 length 20 mm
- 2 x M3 length 5 mm
First mount the camera on the brackets using the long screw.
Then mount the camera on the universal sensor carrier.
Holes used
To mount the sensor on the sensor carrier, use
- 2 x M3 length 5
and the holes shown below :
The camera on the Universal Sensor Carrier, should look like that :
Afterwards mount the Universal Sensor Carrier on the Arm
And your assembly should look like
And when you mount the gripper back in place, the arm should look like :
Powering the sensor
To power the sensor, plug the USB cable at one of the available USB ports.
Go back to Sensors