Difference between revisions of "Mounting Soft two-finger gripper"
From youBot wiki
(Created page with "The [http://www.youbot-store.com/youbot-store/youbots/accessories/soft-two-finger-gripper Soft two-finger gripper] sold from the youBot-Store is produced using 3D Printing Tec...") |
|||
| Line 10: | Line 10: | ||
<br> | <br> | ||
[[File:Soft-2Finger-Gripper-MountingHoles.jpeg |thumb|center| 400px|Soft two-finger Gripper Mounting Holes]] | [[File:Soft-2Finger-Gripper-MountingHoles.jpeg |thumb|center| 400px|Soft two-finger Gripper Mounting Holes]] | ||
| + | |||
| + | Go back to [[Accessories | Accessories]] | ||
Latest revision as of 17:52, 9 February 2015
The Soft two-finger gripper sold from the youBot-Store is produced using 3D Printing Technology to achieve its accuracy in shape, but on the other hand it is based on plastic and therefore:
- is NOT suitable for heavy duty applications
otherwise it might result in a permanent hardware failure!
If you have purchased the gripper from the youbot-store it comes already preassembled, so there isn't much work to do more, just the few following steps.
- Remove the two fingers of the old gripper
- Just use the outer two holes of each old gripper finger to mount the Soft two-finger gripper, with the screws provided, as shown below.
Go back to Accessories
